On MOST Bikes, You Can Slip On the BOOT DR. 
From the Top of the Floorboard in the space between 
the board and the exhaust pipe.  Check for uniform 
guard height, and then tighten the 2 Allen Head 
Screws Underneath.  

IF YOU DON'T HAVE ENOUGH ROOM, YOU WILL NEED 
TO REMOVE THE FLOORBOARD 

Step 1: Remove the Floorboards From Your Bike by Loosening the 2 Bolts That Attach it to its Mounting Bracket.

Step 3: Re-Attach the Floorboards to the Bracket & Tighten Down the 2 Bolts.

Step 4:  You're DONE!!  So get out on the road & RIDE!

Quick & Easy Installation Instructions
for Your Passenger Board BOOT DR:

Using a 5/16” hex wrench, remove the single bolt(s) that
mount the board bracket(s) to the bike. This removes the bracket & board assembly(s) together.

With the board in the extended (down) position, place the
Boot Dr on the inside surface of the board and mark the
location of the mounting holes…these marks should be 6 5/8” inches apart. Prick punch the marks and, using a 9/64” (.140”) twist drill bit, drill two holes thru the board casting.

Attach the board with the supplied (2) stainless-steel
#8 x 3/8” long Phillips Pan-Head Screws.

Note: These are self-tapping screws and should be installed square to the hole, applying a steady pressure as you screw them in.

FOR TOURING MODELS ONLY

When re-installing the left-side board assembly, insert the provided spacer between bracket & bike and use the 2” bolt provided in the kit. This will assure clearing the derby cover when the board is folded up when not in use.

You’re done! So get out, ride safely and enjoy your new
BOOT DR™!

THANK YOU FOR YOUR PURCHASE!